Filter
Top Products
28
FEATURES
Adjustable Headlight
The headlight can be adjusted for vertical aim using the following
procedure.
1. In a well-ventilated area, position the snowmobile on a level surface
with the headlight approximately 25 feet (7.6 m) from a wall.
2. Place the rider or the approximate weight of the rider on the seat or
tunnel floorboards.
3. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
4. Start the engine. Move the headlight switch to high beam.
5. Observe the headlight aim on
the wall. The most intense part
of the headlight beam should be
two inches (5 cm) below the
mark on the wall.
6. If adjustment is necessary,
access the headlight adjuster
knob through the left side
panel. Turn the adjuster knob
clockwise to lower the beam.
Turn the adjuster counter-
clockwise to raise the beam.
2 in. (5 cm)
Lamp Center Height
25 ft. (7.6 m)
X
Lower
Raise