Polaris 200 Quadricycle Offroad Vehicle User Manual


 
33
OPERATION
Starting the Engine
9. Activate the starter for a maximum of five seconds. Release the start
switch when the engine starts.
NOTICE: Operating the vehicle immediately after starting could cause engine
damage. Allow the engine to warm up for several minutes before
operating the vehicle.
10. If the engine does not start, release the start switch, wait five sec-
onds, then attempt to start again. Repeat this procedure until the
engine starts.
11. If the engine slows or stops, move the choke lever half way to the
right to allow proper engine warm-up. Vary the engine RPM
slightly with the throttle to aid in warm-up.
12. When the engine idles smoothly, move the choke lever completely
to the right.
Cold Weather Operation
If the vehicle is used year-round, check the oil level frequently. A rising
oil level could indicate condensation in the bottom of the crankcase,
which can lead to engine damage. Any condensation must be drained.
Tip: Internal engine condensation increases as outside temperature decreases.
If the oil level rises to the top of the sight glass, change the oil immedi-
ately. Always operate the engine long enough to reach operating temper-
ature, which reduces condensation.