Filter
Top Products
Problems in the procedures for updating
Symptom Cause Action
The upgrade process doesn’t
start and the navigation system
boots up as usual.
An incorrect SD memory card has
been inserted.
Eject the inserted SD memory card and insert
the correct upgrade SD memory card.
Upgrade has been already done. Check whether the upgrade was done prop-
erly. If the upgrade has not been doneyet,
consult the nearest authorized service sta-
tion.
The screen that cannotbegin the
upgrade process is displayed.
Eject the upgrade SDmemory card #1,and
display the map of yourcurrent position, and
then reinsert the upgradeSD memory card
#1.
The navigation system does not
work properly after upgrade.
The engine of your vehicle was
stopped or the powersupply to the
navigation system was turned off
during upgrade process.
Consult the nearest authorized service sta-
tion.
Upgrade SD memory card was
pulled out during upgradeprocess.
Consult the nearest authorized service sta-
tion.
Messages in the procedures for updating
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message When What to do
An erroroccurred and the up-
date failed.
Unexpected error occurred inthe
update process.
Consult your local Pioneer dealer if this mes-
sage persist.
En
31
Appendix
Troubleshooting
Troubleshooting