Filter
Top Products
5. Pull the rubber boot out from the
door frame.
6. There are two holes at the bottom
of the rubber boot. Guide the
wire harness into one of the holes.
7. Remove any slack in the wire
harness until the harness is hidden
behind the rubber boot.
8. Remove the plastic molding along
the bottom of the door frame.
9. Pass the wire into the vehicle,
remove any slack in the wire, and
position the rubber boot back in
the door frame. Repeat all of the
previous steps to replace the
mirror on the passenger side door
with the new Signal
®
mirror.
5 6
7 8
9
- 4 -