Filter
Top Products
M
irror replacement
While using sturdy gloves, position your fingers
behind the outboard edge of the mirror. Pull back on
the mirror to dislodge it from the center hub and
remove the mirror from the housing.
If your mirrors have the heater option, disconnect the
heater wires at this time. Carefully remove the foam
disc from the back of the mirror and set it aside.
Carefully peel back the foam insulation on the mirror
housing sail.
Press in the rubber grommet into the mirror housing
that surrounds the mirror harness.
Pull some of the factory wire harness into the mirror
housing. Using the shorter of the two wires from the
kit for the driver side door, guide the end without the
connector into the sheath alongside the existing wire.
Pull the wire through the rubber sheath until six
inches of wire remain exposed.
1 2 3
4 5 6