Filter
Top Products
Pull the rubber grommet back out from the mirror
housing and reposition.
Cut a slot in the foam disc just large enough to
accommodate the anti-rotation prongs on the motor
adaptor (on the Signal® mirror). Place the foam disc
on the back of the Signal® mirror. If your mirrors
have the heater option, connect the heater mirrors at
this time. Connect the Signal
®
mirror mating
connector to the Signal
®
mirror wire harness.
Tuck the wires toward the back of the mirror
housing. Align the Signal
®
mirror over the center
hub of the mirror housing and firmly press the mirror
into the housing until it snaps into position.
7 8 9
- 3 -