Filter
Top Products
3-1
P/N: 4809641a
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
01MAY06 v1.1 Dodge Ram 1500(4809641av1.1)
C. Remove the factory installed straight fitting.
D. Using Teflon sealant, install the supplied
45°. brass fitting so it points back and up
slightly. Thread the straight hose fitting
removed in Step “C” into this using Teflon
sealant. (See Fig. 3.1-b.)
E. Detach wiring harness from the front of the
engine. This allows space for the super-
charger mounting plate. (See Fig. 3.1-b.)
Fig. 3.1-b
A. Remove the factory accessory drive belt by
rotating the tensioner using a 15mm wrench
or socket.
B. Remove the four bolts securing the oil filler
neck using a 10mm deep socket, to be rein-
stalled in a later step. (See Fig. 3.1-a.)
Fig. 3.1-a
F. Remove the three bolts securing the A/C
compressor using a 13mm and 15mm sock-
et. Lift compressor up and let it rest on top
of the valve cover.
G. Using a 1-1/8" wrench or socket, remove the
large bolt on the front of the cylinder head.
(See Fig. 3.1-d.)
Fig. 3.1-b
Fig. 3.1-d
Section 3
SUPERCHARGER INSTALLATION AND ASSEMBLY
3.1 SUPERCHARGER MOUNTING
BRACKET PREPARATION