Filter
Top Products
3-5
P/N: 4809641a
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
01MAY06 v1.1 Dodge Ram 1500(4809641av1.1)
Fig. 3.3-f
H. Tighten the nut on the tensioner pulley using a
3/4" wrench. You will have to bend the upper-
most a/c line up slightly to clear the belt. (See
Fig. 3.3-g.) Also, bend it up slightly at the radi-
ator end until it clears. (Your air conditioner lines
may differ from the picture and some steps may
not be needed.)
Fig. 3.3-g
TENSIONER
NUT
Fig. 3.3-e
Fig. 3.3-h
F. Install the supplied longer accessory drive
belt. Use the factory belt routing with the
exception of going around the supplied idler
and S/C drive pulley. (See Fig. 3.3-e.)
G. Tighten the supercharger drive belt and ten-
sioner by turning the leadscrew clockwise
using a 10mm socket. The belt should be
very tight as it will stretch after being run.
(See Fig. 3.3-f)
I. Reinstall the factory fan and clutch assem-
bly.