Filter
Top Products
6
Testing the SWI-X
Final Installation
Hold the SWI-X infrared emitter (clear blue light at the
end of the four-foot wire) close to the head unit and test
each function of the steering wheel controls. The right
/('RQWKH6:,;ZLOOÀDVKLQGLFDWLQJLWLVVHQGLQJDQ
IR command when each button on the steering wheel
is pressed. If any function does not work, repeat the
programming instructions (starting from Step 11) or refer to
Troubleshooting Guide.
Mount the SWI-X infrared emitter within line of sight of the
head unit, testing continuously to ensure that it will operate
from the chosen position. The LED can be installed in the
center console or overhead console. Install the LED using the
supplied black mounting bezel attached to the LED. Drill a
hole just big enough for the bezel to snap into place, but not
too big for it to fall through. Once the hole is drilled, insert the
LED from behind through the hole and snap bezel onto the
LED. Snap bezel with LED into hole.Complete the head unit
and SWI-X module installation.
VOL
TEMP