Filter
Top Products
3
06-14-07
37)8
Step 8.
To turn IR Extended Mode ON:
Press and release the program-
ming button within 3 seconds.
To leave IR Extended Mode OFF:
Do nothing for 3 seconds.
Note: To change IR Extended Mode later, restart procedure at Step 6.
Steps 11-24 (learning radio commands) must also be repeated.
37)8
37)8
37)8
Programming the SWI-X to Work With the Vehicle
Step 6.
Press and hold programming/
mode button on SWI-X. Turn the
vehicle ignition to the ON position.
Both LEDs on SWI-X
will light.
Step 7.
Release the programming/
mode button.
Both LEDs will turn
off, indicating memory
is cleared, then turn
on again for only 3
seconds.
Both LEDs will turn off.
Step 9.
Press and release the program-
ming/mode button the same
number of times as the desired
version number.
/('VZLOOÀDVKHDFK
time the button is
pressed.
After 3 seconds, LEDs
ZLOOÀDVKWRLQGLFDWHVHW
version number.
Left LED: 10’s place
Right LED: 1’s place
Step 10.
Turn vehicle ignition
to OFF position.
Programming
sequence is complete.
37)8
OFF
ACC
IGN
STRT
OFF
ACC
IGN
STRT
8)73
8)73
37)8
37)8
37)8
IMPORTANT! Some steps of the programming instructions must be completed within a certain number of seconds following the
previous step. Review the complete instruction before beginning the programming sequence.
Step 5.
Refer to Appendix C - Head Units That Require IR Extended Mode On and the Vehicle Appication Guide. Note the IR Extended
Mode Setting and INTERFACE Version Number next to the selected vehicle. Fill in the information below for quick reference.
IR Extended Mode Setting: YES / NO Version Number: ____________
(Circle one)
(Write Vesion Number here)