Filter
Top Products
Black plate (312,1)
Model "Z12-D" EDITED: 2009/ 9/ 17
6. Mark the center of the holes
*
D
with a felt-
tip pen.
7. Carefully drill the two pilot holes using a
0.39 in (10 mm) drill bit at the marked
locations. (Be sure that the drill only
goes through the bumper fascia.)
8. Insert grommets into the hole on the fascia.
9. Insert a flat-blade screwdriver into the
grommet hole to add a 908 turn onto the
part
*
E
.
10. Insert a J-nut into the license plate bracket
before placing the license plate bracket on
the fascia.
11. Install the license plate bracket with the
screws.
12. Install the license plate with bolts that are
not longer than 0.55 in (14 mm).
9-12 Technical and consumer information