Filter
Top Products
10
VEHICLE INFORMATION DISPLAY
When the ignition switch is placed in the ON position, the vehicle
information display shows the following information:
Outside air temperature (if so equipped)
Continuously Variable Transmission (CVT) position indicator
(if so equipped)
Odometer/Instrument brightness control
Twin trip odometer/Trip computer
To display modes of the trip computer press the trip button
01
to highlight the desired mode. Press the trip button
01
for
1 second to reset the information in the highlighted mode.
01
REARVIEW MONITOR (if so equipped)
When the shift lever is moved to the R (REVERSE) position, the monitor
display will automatically change to show the area directly behind the
vehicle. The colored lines on the display screen indicate approximate
distances to objects.
Red 1.5 ft (0.5 m); Yellow 3 ft (1 m); Green 7 ft (2 m) and 10 ft (3 m).
CLOCK SET/DISPLAY ADJUSTMENT
Press the ENTER/SETTINGS button
10
until the on-screen clock mode is displayed, then
turn the TUNE/SCROLL dial
11
to toggle between clock display on or off.
To adjust the time, press the ENTER/SETTINGS button repeatedly until the Clock Adjust mode
is displayed on the screen.
The hours will begin blinking, adjust by turning the TUNE/SCROLL dial left or right and press
the setting control knob.
The minutes will begin blinking, adjust by turning the TUNE/SCROLL dial left or right and
press the ENTER/SETTINGS button to set. The display will return to the regular clock
display after 10 seconds.
USB JACK WITH iPod
®
CONNECTIVITY (if so equipped)
The USB input jack is located in the lower center of the instrument panel.
To connect a compatible USB device, open the protective cover on the
USB jack, and insert the USB device into the jack. When a compatible
storage device is plugged into the jack, compatible audio or video
files on the storage device can be played through the vehicle’s audio
system. Video file playback is only available on vehicles with navigation.
To connect an iPod
®
, open the USB jack cover, connect the USB end of the cable supplied
with your iPod
®
to the jack, then connect the other end of the cable to the iPod
®
. When the
ignition switch is in the ACC or ON position, the battery of your iPod
®
(if compatible) will
charge while connected to your vehicle.