Filter
Top Products
CLOCK SET/ADJUSTMENT
Ⅲ Press and hold the CLOCK button for approximately 2 seconds.
Ⅲ The display will show “H-Seek M-Tune.”
Ⅲ Press the SEEK/TRACK button to adjust the hours.
Ⅲ Press the TUNE/FF·REW button to adjust the minutes.
Ⅲ Press the CLOCK button again to exit the clock set mode.
VEHICLE INFORMATION DISPLAY
When the ignitionswitch is turnedto the ON position,the vehicle
information display shows the following information.
Ⅲ Outside air temperature (if so equipped)
Ⅲ Shift range position indicator
Ⅲ Odometer
Ⅲ Trip computer (if so equipped)
TRIP COMPUTER (if so equipped)
The trip computer readout is located between the speedometer and
tachometer. With the ignition key in the ON position or the vehicle
running, you can select an item by pressing the
button on the
instrument panel. Each time the
button is pressed, the display
mode will change as follows:
Ⅲ TRIP “A” – Measures the distance of one specific trip.
Ⅲ TRIP “B”– Measures the distance of a second specific trip.
Ⅲ DISTANCE TO EMPTY (dte) – Estimates the distance that
can be driven before refueling.
Ⅲ AVERAGE SPEED (MPH or km/h) – Shows the average
speed since the last reset.
Ⅲ AVERAGE FUEL CONSUMPTION (MPG or l/100 km) –
Shows the average fuel consumption since the last reset.
Ⅲ JOURNEY TIME – Shows the time since the last reset.
Ⅲ RESET– Press the
button on theinstrument panel for more than1 second to reset
the selected mode to zero. Press the
button on the instrument panel for more than
3 seconds and all modes will reset to zero (except TRIP “A”).
10