Filter
Top Products
DCA-220SSJ/SSJU — OPERATION AND PARTS MANUAL — REV. #0 (02/04/14) — PAGE 55
1
1. Perform steps 1 through 6 in the
Before Starting
section
as outlined in the
Manual Starting
Procedure
.
2. Place the
engine speed switch
(Figure 54) in the HIGH
position
4. Continue operating the generator as s outlined in the
Manual Start-up
procedure (start at step 5).
Figure 55. MPEC Control Switch (AUTO)
When running the generator in the AUTO mode, remember
the generator can start up at any time without warning.
NEVER attempt to perform any maintenance when the
generator is in the auto mode.
WARNING - AUTO MODE MAINTENANCE
DCA-220SSJ/SSJU — GENERATOR START-UP PROCEDURE (AUTO MODE)
When starting generator in AUTO mode use the "
Manual
Start-up" procedure except where noted (see below).
CAUTION - ENGINE SPEED SWITCH
The
Engine Speed Switch
must be set to the “High”
position when running in the
Auto-Start
mode. Failing to
set the switch in the proper position can result in damage
to your generator when it turns on.
3. Place the
MPEC Control Switch
(Figure 55) in the AUTO
position
Figure 54. Engine Speed Switch (High)
When the MPEC
control switch
is placed in the AUTO
position, the engine glow plugs will be warmed and the
engine will start automatically.
NOTICE