Filter
Top Products
PAGE 34 — DCA20SPXU2 (WITH MLT20 SERIES) • OPERATION AND PARTS MANUAL — REV. #0 (01/18/13)
NORMAL SHUTDOWN PROCEDURE
To shutdown the generator, use the following procedure:
1. Place the main, G.F.C.I., and aux. circuit breakers
(Figure 37) in the OFF position.
Figure 37. Main, Aux. and GFCI
Circuit Breakers (OFF
2. Let the engine cool by running it at low speed for 3-5
minutes with no load applied.
WARNING
NEVER stop the engine suddenly except in an
emergency.
GENERATOR SHUT-DOWN PROCEDURES
3. Place the MPEC Control Switch (Figure 38) to the
OFF/RESET position.
Figure 38. MPEC Control Switch (Off/Reset)
4. Verify that all the status LEDs on the MPEC display
are OFF (not lit).
5. Remove all loads from the generator.
6. Inspect entire generator for any damage or loosening of
components that may have occurred during operation.
EMERGENCY SHUTDOWN PROCEDURE
1. Place the main, G.F.C.I., and aux. circuit breakers
(Figure 37) in the OFF position.
AUTO
MANUAL
OFF/RESET