Filter
Top Products
PAGE 26 — DCA20SPXU2 (WITH MLT20 SERIES) • OPERATION AND PARTS MANUAL — REV. #0 (01/18/13)
OUTPUT TERMINAL PANEL CONNECTIONS
UOV TERMINAL OUTPUT VOLTAGES
240/120V outout voltages can be obtained using the output
terminal lugs.
The voltage regulator (VR), Figure 14 allows the user to
increase or decrease the selected voltage.
1Ø-240 Output Terminal Voltage
1. Connect the load wires to the output terminal lugs as
shown in Figure 13.
Figure 13. Output Terminal Lugs
1Ø-240 Volt Connections
2. Turn the voltage regulator knob (Figure 14) clockwise
to increase voltage output, turn counterclockwise to
decrease voltage output. Use voltage regulator
adjustment knob whenever fine tuning of the output
voltage is required.
Figure 14. Voltage Regulator Knob
1Ø-120 Output Terminal Voltage
1. Connect the load wires to the output terminal lugs as
shown in Figure 15.
Figure 15. Output Terminal Lugs
1Ø-120 Volt Connections
2. Turn the voltage regulator knob (Figure 14) clockwise
to increase voltage output, turn counterclockwise to
decrease voltage output.
NOTICE
ALWAYS make sure that the connections to the UVO
terminal lugs are secure and tight. The possibility of
arcing exists, that could cause a fire.