Filter
Top Products
MAYCO C-30HDNI (PRECISION) PUMP — OPERATION AND PARTS MANUAL — REV. #7 (04/03/12) — PAGE 41
Clutch Lining Replacement
(For P/N EM14320 Clutch Assembly Only)
The normal lining thickness measures 3/16 of an inch. If the
clutch starts to slip or make an usual noise, it may be necessary
to replace the lining. Please note that the lining retaining rivets
should not be exposed
to the rotating weight.
The following procedure will assist you in replacing the lining.
1. Remove worn out lining and rivets. Check clutch springs and
flyweights for wear.
2. Cut 1/8 in. off of each end of clutch lining. Slide lining into
place. Insert one rivet into clutch lining hole. (Make sure rivet
goes from inside out.) Wedge a flathead screwdriver between
clutch flyweight and rivet head.
3. Adjust screwdriver so that the rivet sticks out from the clutch
housing approximately 1/8 of an inch. With a flat punch, pen
the ends on the rivet so that it locks in place with the clutch
housing. Repeat this procedure for all remaining clutch rivets.
The clutch lining is a normal
maintenance item and will require
periodic replacement.
C-30HDNI (PRECISION) PUMP — MAINTENANCE (PUMP)
NOTE