Mitsubishi MZ360234EX (DNX7200ZM4) GPS Receiver User Manual


 
78 DNX7200
Setup menu
Security Code Setup
You can set a security code to protect your
receiver system against theft.
• When the Security Code function is activated it cannot
be released.
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
1 Display the Security Code Setup screen
Touch [Security] in the SETUP Menu (page 64).
1
2
3
1 Displays the Security code input screen.
2 Turns the SI function on or off.
If turned "On", the burglar alarm lamp
flashes when the vehicle ignition is off.
( On)
3 Returns to the original screen.
2 Start Security Code setup
• If you have already completed the code registration,
cannot touch
.
3 Enter a security Code
Input four-digit number.
4 Register your security code
5 Reenter the security code
Reenter the same security code as that you
have entered in Step 3 for confirmation.
• If you enter a different security code, the screen returns
to Step 3 (for the first code entry).
6 Register the security code again
Now, your security code is registered.
If you press the Reset button or if you
disconnect your receiver from the battery after
the code registration, you need to enter the
registered security code.