Metra Electronics 99-7001 Automobile Accessories User Manual


  Open as PDF
of 8
 
14
TALON 1995-98, ECLIPSE 1995-98, COLT, SUMMIT, MIRAGE, STEALTH, 3000GT,
DIAMANTE, GALANT, MONTERO: No cutting of the dash or dash trim bezel is required.
Skip to the Wiring Preparation in step #8.
TALON, ECLIPSE, LASER 1990-94: If keeping the factory pocket is desired, cut and remove
the inside half of each pocket mount located on the back of the dash trim bezel. (see Fig. A)
SUMMIT (wagon), EXPO, COLT VISTA: Cut and remove ¼" from the top edge of the dash
cavity opening. (see Fig. B). If keeping the factory pocket is desired, cut and remove the
pocket mounts located on the back of the dash trim bezel. (see Fig. C)
7
Fig. B
Fig. C
Fig. A
8 9
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with those screws
previously removed.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
¼"
 previous