Filter
Top Products
10
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws above the climate controls.
Unclip the bottom of the dash trim bezel and
remove the bezel. Remove (4) screws
securing the factory head unit and
disconnect the wiring.
1 2
"B"
"B"
3
DASH TRIM BEZELS WITH A DIVIDED RADIO OPENING: If keeping the factory pocket is
NOT desired, cut and remove the upper rib from the radio openingand snap the Filler Bar
onto the bottom of the Radio Housing. (see Fig. A). If keeping the factory pocket is desired,
cut and remove the upper rib from the radio opening and the bottom portion of the Radio
Housing. (see Fig. B). Skip to the Installation Instructions for ALL VEHICLES on Page #12.
DASH TRIM BEZELS WITH AN UNDIVIDED RADIO OPENING: If keeping the factory
pocket is NOT desired, cut and remove the lower rib from the radio opening and the top portion
of the Radio Housing. (see Fig. C). If keeping the factory pocket is desired, cut and remove
the lower rib from the radio opening, the top portion of the Radio Housing and the bottom
portion of the Housing. (see Fig. D). Skip to the Installation Instructions for ALL VEHICLES on
Page #12.
Fig. A
Fig. B
Fig. C
Fig. D
MITSUBISHI Montero 1992-96
Cut and remove mounting tabs "A" and "B"
on the Radio Housing. Cut and remove all
mounting tabs on Bracket Set #1 EXCEPT
tabs "B". The mounting tabs can be
identified by the stamped letter on the back
of each tab.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the radio/climate control trim bezel and
remove the bezel. Remove (4) Phillips
securing the factory head unit and
disconnect the wiring.
MITSUBISHI Montero Sport 2000-02
1
"B"
"X"
"B"
2
3
Cut and remove the lower rib from the radio opening and
the top portion of the Radio Housing. Skip to step #5 on
Page #13.
Cut and remove mounting tabs "A" and "B"
on the Radio Housing. Locate mounting
tabs "B" on Bracket Set #3 and cut and
remove the mounting legs containing tabs
"A" by cutting along scored lines "X". The
mounting tabs can be identified by the
stamped letter on the back of each tab.
11