Filter
Top Products
74
Garage Door Opener
1 Remote control transmitter
located on inside rear view
mirror
2 Portable remote control
transmitter
The built-in remote control is capable of
operating up to three separately
controlled objects.
Warning!
When programming a garage door
opener, the door moves up or down.
When programming or operating the
remote control make sure there is no
possibility of anyone being harmed by
the moving door.
Note:
Certain types of garage door openers
are incompatible with the integrated
opener. If you should experience
difficulties with programming the
transmitter, contact your authorized
Mercedes-Benz dealer or call
Mercedes-Benz Customer Assistance
Center (in the U.S.A. only) at 1-800-
FOR-MERCEDES.
Programming or reprogramming the
remote control:
1. Turn key in steering lock to position
1 or 2.
2. Press and hold one button of the
remote control located on the inside
rear view mirror until its control light
begins to flash at a rate of about
once a second. Continue holding
down the button.
Note:
The light blinks immediately if the
remote control is being programmed
for the first time, or if its memory
was previously erased. If you are
reprogramming a previously used
button, the light will flash after about
20 seconds.
3. Hold end opposite to battery of
portable remote control against
the inside rear view mirror trans-
mitter to be programmed. While
still holding down the button on
the transmitter on the inside rear
view mirror, press down the but
ton on your portableremote control,
until the inside rear view