Filter
Top Products
115
Replacing bulb:
To prevent a possible electrical short
circuit, switch off lamp prior to
replacing a bulb.
When replacing bulbs, install only 12
volt bulbs with the specified watt
rating.
When replacing halogen bulbs do not
touch glass portion of bulb with bare
hands. Use plain paper or a clean cloth.
Warning!
Halogen lamps contain pressurized
gas. A bulb can explode if you:
• touch or move it when hot,
• drop the bulb,
• scratch the bulb.
Bulb for Low Beam (Xenon)
Warning!
Because of high voltage in Xenon
lamps, it is dangerous to replace
the bulb or repair the lamp and its
components. We recommend that
you have such work done by a
qualified technician.
Bulb for High Beam H1 (55 W) Open
hood.
Depress latch (4) and remove cover (3).
Pull off electrical connector (10).
Unhook clamping ring and remove
bulb.
Insert new bulb (seating properly in
cutouts of bulb socket), and mount
clamping ring. Reinstall and push
electrical connector on securely.
Reinstall bottom end of cover (3) and
push against top end of cover until
properly seated.
Check lamp for proper operation.
Bulb for high beam H1 (55 W)
Open hood.
Depress latch (2) and remove
cover (1).
Pull off electrical connector (9).
Unhook clamping ring and remove
bulb.
Insert new bulb (seating properly in
cutouts of bulb socket), and mount
clamping ring. Reinstall and push
electrical connector on securely.
Reinstall bottom end of cover (1) and
push against top end of cover until
properly seated.
Check lamp for proper operation.