Filter
Top Products
i
The center console in the 2nd row of seats
can remain in place if it is installed in the
foremost position (position1)
(Y page 249). However, the loading surface
will not be level.
X
Remove the head restraint of the seat
concerned (Y page 102).
X
Lay the head restraints on the seat cushion
of the corresponding seat.
X
Relieve the pressure on backrest : and
pull release lever ; upwards in the
direction of the arrow beyond the pressure
point to the stop.
Backrest : and the seat are unlocked.
X
Fold backrest : forwards until it is resting
horizontally on the seat cushion.
X
Now push backrest : down further until
seat cushion ; engages on the floor.
Folding down the seats in the 3rd row of
seats
X
Push down the respective head restraints
in the 3rd row as far as they will go
(Y page 102).
X
Clamp the seat belt behind retainer ;.
X
Pull release handle : of backrest =
upwards in the direction of the arrow.
Backrest = is released.
X
Fold backrest = slowly forwards.
Seat cushion C is released and moves
automatically to a vertical position.
i
Loop D can be used to pull the backrests
of the 3rd row of seats upright when the
seats are moved into the original position
(Y page 254).
X
After it has been moved to a vertical
position automatically, fold seat cushion
C further forwards until it reaches a
horizontal position. In doing so, make sure
that guide pin A of seat cushion C
catches fully in recess ? of backrest B.
Stowage areas
253
Loading, stowing and features
BA 251 USA, CA Edition A 2011; 1; 3, en-US
d2sboike Version: 3.0.3.5
2010-04-16T14:31:55+02:00 - Seite 253
Z