Filter
Top Products
Driving systems
Display messages Possible causes/consequences and M Solutions
°
Vehicle Rising
Wait Briefly
The vehicle level is too low.
X
Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
X
Wait until the display message disappears before pulling away.
°
STOP Car Too Low
G
Risk of accident
You have pulled away while the vehicle level is still too low or
AIRMATIC is faulty.
AIRMATIC sets the vehicle to the selected level after a short
period. While the display message is displayed:
X
Make only slight steering movements. The front fender or the
tires could otherwise be damaged when the steering movement
is too large.
X
Listen for scraping sounds.
X
Do not drive faster than 50 mph (80 km/h).
If the display message continues to be displayed:
X
Have the vehicle checked at a qualified specialist workshop.
°
Level Selection
Not Permitted
You cannot change the vehicle level because you are exceeding
the permissible speed for the selected vehicle level.
X
Drive more slowly and then select the desired vehicle level again
(Y page 183).
°
Compressor Cooling
Down
You have selected a higher vehicle level. The compressor first
needs to cool down because of frequent level changes.
X
Drive in a manner appropriate for the current vehicle level.
X
Make sure that there is sufficient ground clearance.
X
Allow the compressor to cool down.
When the compressor has cooled down, the display message
disappears. The vehicle then continues rising to the selected
level.
°
Malfunction
AIRMATIC is faulty.
X
Do not drive faster than 50 mph(80 km/h).
X
Make sure that there is sufficient ground clearance.
X
Have the vehicle checked at a qualified specialist workshop.
228
Display messages
On-board computer and displays
BA 251 USA, CA Edition A 2011; 1; 3, en-US
d2sboike Version: 3.0.3.5
2010-04-16T14:31:55+02:00 - Seite 228