Filter
Top Products
overheating. In the Service Booklet, you can
find information on the intervals for renewal.
The renewal interval is determined by the
coolant type and the cooling system design.
The renewal interval in the Service Booklet is
only valid if the coolant is added or renewed
with Mercedes-Benz approved products.
Therefore, only use MB 326.0 antifreeze/
corrosion inhibitor or another Mercedes-Benz
approved product of the same specification.
Information on other Mercedes-Benz
approved products of the same specification
can be obtained at any authorized Mercedes-
Benz Center or on the Internet at
http://bevo.mercedes-benz.com.
The coolant is checked at every service date
at an authorized Mercedes-Benz Center.
The antifreeze/corrosion inhibitor
concentration in the cooling system should:
R
be at least 50%. This will protect the cooling
system against freezing down to around
-35 ‡ (-37 †).
R
not exceed 55% (antifreeze protection
down to -49 ‡ (-45 †); otherwise, heat will
not be dissipated as effectively.
If the coolant level is too low, MB 326.0
antifreeze/corrosion inhibitor should be
added. Have the cooling system checked for
leaks.
Windshield and headlamp cleaning
system
G
Warning
Washer solvent/antifreeze is highly
flammable. Do not spill washer solvent/
antifreeze on hot engine parts, because it may
ignite and burn. You could be seriously
burned.
X
Use MB Windshield Washer Concentrate
MB SummerFit.
X
At temperatures above freezing: add 1
part MB SummerFit to 100 parts water, e.g.
1.34 fl oz (40 ml) MB SummerFit to 1 gal
(4.0 l) of water.
X
At temperatures below freezing: add 1
part MB SummerFit to 100 parts washer
fluid, e.g. 1.34 fl oz (40 ml) MB SummerFit
to 1 gal (4.0 l) of water.
Vehicle data
Vehicle data, ML 350 BlueTEC 4MATIC
(164.125)
The data quoted here refers specifically to a
vehicle with standard equipment. Contact an
authorized Mercedes-Benz Center for the
data for all vehicle variants and trim levels.
Vehicle dimensions, ML 350 BlueTEC
4MATIC
Vehicle length
188.5 in (4788 mm)
Vehicle width
including exterior
mirrors
85.5 in (2170 mm)
Vehicle height
71.5 in (1815 mm)
72
69.8 - 73.0 in (1774 -
1854 mm)
73
Wheelbase
114.8 in (2915 mm)
Front track
63.7 in (1619 mm)
Rear track
63.8 in (1621 mm)
Ground clearance
8.3 in (210 mm)
72
7.3 - 10.3 in (186 -
261 mm)
73
Turning circle
38.1 ft (11.6 m)
72
Vehicles with steel-spring suspension.
73
Vehicles with AIRMATIC package: the values vary depending on the level set for the vehicle suspension.
Vehicle data
363
Technical data
BA 164.1 USA, CA Edition B 2011; 1; 2, en-US
d2mskot Version: 3.0.3.5
2010-04-21T17:25:06+02:00 - Seite 363
Z