Filter
Top Products
a circle without impeding the remaining
traffic.
In order to calibrate the compass correctly,
observe the following points:
R
calibrate the compass in the open and not
in the vicinity of steel structures or high-
voltage power lines
R
switch off electrical consumers such as
climate control, the windscreen wipers or
the rear window heating
R
close all doors and the trunk lid
X
Switch on the ignition.
X
Press and hold button = for approximately
six seconds until the C symbol appears in
compass display ;.
X
Drive a full circle at approximately 3 mph
(5 km/h) to 6 mph (10 km/h).
Once the calibration has been successfully
completed, the current heading appears in
compass display ;.
Floormat on the driver's side
G
Warning!
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
X
Slide seat backwards.
X
To install: place the floormat in position.
X
Press floormat eyelets : onto retainer
pins ;.
X
To remove: pull the floormats off
retainers ;.
X
Remove the floormat.
236
Features
Loading, stowing and features
BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe Version: 3.0.3.6
2010-05-20T09:17:30+02:00 - Seite 236