Filter
Top Products
X
Gently press the new bulb into bulb socket
=.
X
Place bulb socket = back into the housing
and turn it clockwise until it engages.
Front turn signal lamp bulb
X
Turn bulb socket ; with the bulb
counterclockwise and remove it.
X
Gently press onto the bulb and turn it
counterclockwise out of bulb socket ;.
X
Gently press the new bulb into bulb
socket ; and turn it clockwise until it
engages.
X
Place bulb socket ; back into the housing
and turn it clockwise until it engages.
Parking and standing lamp bulb
X
Turn bulb socket ? with the bulb
counterclockwise and remove it.
X
Pull the bulb out of bulb socket ?.
X
Gently press the new bulb into bulb
socket ?.
X
Place bulb socket ? back into the housing
and turn it clockwise until it engages.
Replacing bulbs for rear lamps
Tail lamp unit
Since replacing bulbs in the tail lamp unit is a
technically highly demanding process, we
recommend to have them replaced at an
authorized Mercedes-Benz Center.
License plate lamps
X
Switch off the ignition.
X
Turn the exterior lamp switch to position
$.
X
Open the trunk.
X
Loosen screws : of lamp cover to be
removed.
X
Remove lamp cover ;.
X
Replace the bulb.
X
Reinstall lamp cover ;.
X
Retighten screws :.
Replacing wiper blades
Safety notes
G
Warning!
For safety reasons, switch off the wipers and
remove the SmartKey from the starter switch
before replacing a wiper blade. Otherwise, the
wiper motor could suddenly turn on and cause
injury.
G
Warning!
Wiper blades are components that are subject
to wear and tear. Replace the wiper blades
twice a year, preferably in the spring and fall.
Otherwise the windshield will not be wiped
properly. As a result, you may not be able to
observe surrounding traffic conditions and
could cause an accident.
Replacing wiper blades
271
Practical hints
171_AKB; 3; 60, en-US
d2ureepe, Version: 2.11.8.1
2009-05-11T16:00:23+02:00 - Seite 271
Z