Filter
Top Products
The following functions are available:
R
Switching daytime running lamp mode on
or off (USA only) (Y page 106)
R
Switching locator lighting on or off
(Y page 106)
R
Switching night security illumination
(Headlamps delayed shut-off feature) on or
off (Y page 107)
R
Switching interior lighting delayed shut-off
on or off (Y page 107)
Switching daytime running lamp mode on
or off (USA only)
X
Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X
Press button &.
X
Move the selection marker with button
W or X to the Lighting submenu.
X
Press button & or * repeatedly until
the message Headlamp Mode appears in
the multifunction display.
The selection marker is on the current
setting.
X
Press button W or X to select
manual operation (Manual) or daytime
running lamp mode (Constant).
With daytime running lamp mode switched on
and the exterior lamp switch in
position $ or Ã, the low-beam
headlamps are switched on when the engine
is running.
In low ambient light conditions the following
lamps will come on additionally:
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
For more information on the daytime running
lamp mode, see (Y page 72).
For safety reasons, resetting all the functions
of all submenus to the factory settings while
driving (Y page 102) will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Lighting Cannot be completely reset
to factory settings while driving.
Switching locator lighting on or off
With the locator lighting feature activated and
the exterior lamp switch in position Ã, the
following lamps will come on during darkness
when the vehicle is unlocked using button
% on the SmartKey:
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
R
Front fog lamps
The locator lighting goes out when the driver’s
door is opened.
If you do not open the driver’s door after
unlocking the vehicle with the SmartKey, the
lamps will go out automatically after
approximately 40 seconds.
X
Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X
Press button &.
X
Move the selection marker with button
W or X to the Lighting submenu.
X
Press button & or * repeatedly until
the message Surround Lighting
Function appears in the multifunction
display.
The selection marker is on the current
setting.
106
Control system
Controls in detail
171_AKB; 3; 60, en-US
d2ureepe, Version: 2.11.8.1
2009-05-11T16:00:23+02:00 - Seite 106