Filter
Top Products
Display messages
Possible causes/consequences and X Solutions
+
Key Not
Detected
(message
appears in
white)
The SmartKey with KEYLESS-GO is momentarily not detected.
X
Change the position of the SmartKey in the vehicle.
X
If necessary, remove the KEYLESS-GO button from the
starter switch (Y page 80).
X
Operate the vehicle with the SmartKey in the starter switch.
+
Pull
starting
button
out then
insert
key.
The SmartKey with KEYLESS-GO is permanently not detected.
X
Remove the KEYLESS-GO button from the starter switch
(Y page 80).
X
Operate the vehicle with the SmartKey in the starter switch.
X
Contact an authorized Mercedes-Benz Center.
~
Bluetooth
Ready
The telephone has not yet been connected to the COMAND
system via Bluetooth
®
.
X
Connect the telephone to the COMAND system via
Bluetooth
®
.
¥
Top Up
Washer
Fluid
The fluid level has dropped to approximately
1
/
3
of total
reservoir capacity.
X
Add washer fluid (Y page 226).
Engine
Display messages
Possible causes/consequences and X Solutions
+
Top Up
Coolant
See
Operator’s
Manual
The coolant level is too low.
X
Add coolant (Y page 225).
X
If you have to add coolant frequently, have the cooling
system checked at an authorized Mercedes-Benz Center.
G
Warning!
Do not spill antifreeze on hot engine parts. Antifreeze contains ethylene glycol which may burn
if it comes into contact with hot engine parts. You could be seriously burned.
!
Do not ignore the low engine coolant level warning. Extended driving with the message
and
symbol displayed may cause serious engine damage not covered by the Mercedes-Benz
Limited Warranty.
Do not drive without sufficient amount of coolant in the cooling system. The engine will
overheat causing major engine damage.
290
Vehicle status messages in the multifunction display
Practical hints
251_AKB; 4; 52, en-US
d2ureepe, Version: 2.11.8.1
2009-03-23T09:22:52+01:00 - Seite 290