Filter
Top Products
Make sure the cable clamps do not touch
any other metal part while the other end is
still attached to a battery.
Connecting the jumper cables
Your vehicle is equipped with two jump start
terminals in the engine compartment.
Position C represents the charged battery of
another vehicle or an equivalent starter pack.
X
Make sure the two vehicles do not touch.
X
Switch off all electrical consumers.
X
Engage the parking brake.
X
Make sure the automatic transmission is in
park position P.
X
Open the hood, see Operators' Manual.
X
Flip up cover : of positive terminal = in
direction of arrow.
X
Connect positive terminal ; of charged
battery C with positive terminal = with a
jumper cable. Clamp the cable to positive
terminal ; of charged battery C first.
X
Slide cover A from negative terminal B in
direction of arrow.
X
Connect negative terminal ? of charged
battery C with negative terminal B with
a jumper cable. Clamp the cable to
negative terminal ? of charged battery
C first.
Starting the combustion engine
X
Start the engine of the vehicle with the
charged battery and run it at an engine
speed slightly above idle speed.
X
Make sure the automatic transmission is in
park position P.
X
Starting the jump start process with
the SmartKey: To start the charging
process for the high-voltage battery, turn
the SmartKey in the starter switch first into
starting position 3.
X
Turn the SmartKey back into ignition
position 2.
X
Starting the jump start process with
KEYLESS-GO: Depress the brake pedal
during the starting procedure.
34
Practical hints
164_ZA; 2; 2, en-US
d2ureepe, Version: 2.11.8.1
2009-05-12T15:08:04+02:00 - Seite 34