Filter
Top Products
G
Warning!
When the READY indicator in the instrument
cluster is on while the combustion engine is
off, the combustion engine has been turned
off automatically. All vehicle systems
continue
to be active as long as the ignition is
switched on. When you open the driver’s door
and unbuckle the seat belt with the READY
indicator on, while the automatic
transmission is in position N or P, the
combustion engine starts automatically.
Therefore, always do the following before
leaving the vehicle:
R
Engage the parking brake.
R
Shift the automatic transmission into park
position P.
R
Switch off the ignition. The READY indicator
goes out.
The combustion engine turns off
automatically when the system determines
that it is not needed. The combustion engine
does not turn off automatically when
R
the operation strategy requires that the
combustion engine is running
R
the self-diagnosis of the combustion
engine management is still running
R
the combustion engine is running below or
above the operating temperature
R
the catalytic converter is running below the
operating temperature
R
the vehicle is being driven up an extremely
steep incline
R
the hybrid components are below or above
their operating temperature
R
the accelerator pedal is being depressed to
hard
R
the vehicle speed is above 34 mph
(55 km/h)
R
the automatic transmission is
malfunctioning
R
the hood is open
R
the high-voltage battery is not charged
sufficiently
Driving off
G
Warning!
When your vehicle is in electric drive mode the
engine produces significantly lower noise
levels. Other motorists or pedestriants,
especially those who are visually or hearing
impaired,
may be unable to hear your vehicle
while it is in motion. This is particularly true
when driving at lower speeds and during
parking maneuvers. At all times, it is the
responsibility of the driver to be aware of their
surroundings, especially in these low speed
situtations. Otherwise other road users could
be seriously or fatally injured.
Depress the brake pedal and shift the
automatic transmission into drive position D
or reverse gear R. If the message Depress
brake to shift out of P. appears in the
multifunction display:
X
Depress the brake pedal with somewhat
greater force and select the desired
transmission position.
i
Read and observe messages that may
appear in the multifunction display
(Y page 24).
For
more information on driving off, refer to
the Operator’s Manual.
Driving
Driving tips
R
Think ahead and keep sufficient distance.
R
Avoid frequent and rapid acceleration as
well as abrupt braking.
Controls in detail
17
164_ZA; 2; 2, en-US
d2ureepe, Version: 2.11.8.1
2009-05-12T15:08:04+02:00 - Seite 17
Z