Filter
Top Products
209
Controls in detail
Power windows
Fully opening the windows
(Express-open)
̈ Press switch 2 to 5 past the resis-
tance point and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈ Pull switch 2 to 5 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
Stopping windows during Express-op-
eration
̈ Press or pull the respective power win-
dow switch again.
Synchronizing power windows
The power windows must be synchronized
ț after the battery has been disconnect-
ed
ț if the power windows cannot be fully
opened (Express-open) or closed
(Express-close)
Synchronizing
̈ Close all doors.
̈ Switch on the ignition (୴ page 38).
̈ Pull switch 2 to 5 until the side win-
dows are completely closed.
̈ Hold on to switches 2 to 5 for
approximately 1 second.
The power windows are synchronized.
Warning! G
Driver’s door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not operate.
!
If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly.
Remove the obstruction, pull the respective pow-
er window switch again past the resistance point
and release.
If the window still does not close when there is
no obstruction, pull and hold the respective pow-
er window switch. The side window will then
close without the obstruction sensor function.