Filter
Top Products
188
Controls in detail
Good visibility
1 Sun visor
2 Mirror cover
3 Mirror lamp
4 Mounting
5 Vanity mirror
̈ Swing sun visors 1 down when you
experience glare.
̈ To use the vanity mirror 5, lift up the
mirror cover 2.
Make sure the sun visor is properly
engaged in the mounting 4.
Lamp 3 switches on.
If sunlight enters through a side window:
̈ Disengage sun visor 1 from
mounting 4.
̈ Pivot sun visor to the side.
Rear window sunshade*
The switch is located in the center console.
1 Rear window sunshade switch
̈ Switch on the ignition (୴ page 38).
̈ Press switch 1 briefly to raise the sun-
shade.
̈ Press switch 1 briefly to lower the
sunshade.
Always raise the sunshade fully for its sup-
port against the window frame.
i
If sun visor 1 is disengaged from
mounting 4 with mirror cover 2 open, mirror
lamp 3 will switch off.
Warning! G
When operating the rear window sunshade,
be sure that there is no danger of anyone
being harmed by the raising or lowering pro-
cedure.
The raising or lowering procedure can be
immediately halted by briefly pressing
switch 1. To reverse direction of move-
ment, press switch 1 again.