Filter
Top Products
56
Getting started
Parking and locking
Turning off engine
̈ Place the gear selector lever in
position P.
̈ Turn the SmartKey in the starter switch
to position 0.
̈ Remove the SmartKey from the starter
switch.
The immobilizer is activated.
Releasing seat belts
̈ Press the seat belt release button
(
୴ page 43).
Allow the retractor to completely
rewind the seat belt by guiding the
latch plate.
Locking
i
Always set the parking brake in addi-
tion to shifting to position P.
On slopes, turn the front wheels
towards the road curb.
i
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure there is no
possibility of someone getting caught in a
door during closing.
Warning! G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.