Filter
Top Products
275
Controls in detail
Useful features
Step 5:
̈ After the indicator lamp 1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter but-
ton.
Step 6:
̈ Press and hold the just-trained signal
transmitter button (2, 3 or 4) and
observe the indicator lamp 1.
If the indicator lamp 1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or 4) is pressed and re-
leased.
Step 7:
̈ To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Rolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
i
The indicator lamp 1 flashes immedi-
ately the first time the signal transmit-
ter button is programmed. If this button
has already been programmed, the in-
dicator lamp will only start flashing af-
ter 20 seconds.
i
If the indicator lamp 1 flashes rapidly
for about 2 seconds and then turns to a
constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.