Filter
Top Products
48
Getting started
Driving
̈ Release parking brake by pulling on
handle 1.
The warning lamp ; (USA only)
or 3 (Canada only) in the
instrument cluster goes out.
Driving
̈ Depress the brake pedal.
̈ Move gear selector lever to position D
or R.
̈ Release the brake pedal.
̈ Carefully depress the accelerator.
Once the vehicle is in motion, the auto-
matic central locking system engages
and the locking knobs drop down.
After a cold start, the automatic transmis-
sion shifts at a higher engine revolution.
This allows the catalytic converter to reach
its operating temperature earlier.
i
Wait for the gear selection process to
complete before setting the vehicle in
motion.
i
You can open a locked door from the
inside. Open door only when conditions
are safe to do so.
You can deactivate the automatic
locking using the control system
(
୴ page 143).
!
Simultaneously depressing the
accelerator pedal and applying the
brake reduces engine performance and
causes premature brake and drivetrain
wear.
!
If you hear a warning signal when driv-
ing off, you have forgotten to release
the parking brake.
Release the parking brake.
Warning! G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of loss of control.
!
Place the gear selector lever in
position R only when the vehicle is
stopped in order to avoid damaging the
transmission.
!
Do not run cold engine at high engine
speeds. Running a cold engine at high
engine speeds may shorten the service
life of the engine.