Filter
Top Products
50
Getting started
Driving
Single wipe
̈ Press switch briefly in the direction of
arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
̈ Push switch in the direction of
arrow 1 past the resistance point.
The windshield wiper operates with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system”
(
୴ page 243).
Problems while driving
The engine runs erratically and misfires
ț An ignition cable may be damaged.
ț The engine electronics may not be op-
erating properly.
ț Unburned gasoline may have entered
the catalytic converter and damaged it.
̈ Give very little gas.
̈ Have the problem repaired by an au-
thorized Mercedes-Benz Center as
soon as possible.
!
If anything blocks the windshield wip-
ers (leaves, snow, etc.), switch them off
immediately.
ț For safety reasons, withdraw
SmartKey from starter switch be-
fore attempting to remove any
blockage.
ț Remove blockage.
ț Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position I,
ț set the combination switch to the
next highest wiper speed
ț have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center