Filter
Top Products
Black plate (222,1)
l
A new CD may have rough edges on
its inner and outer perimeters. If a disc
with rough edges is used, proper
setting will not be possible and the CD
player/In-dash CD changer will not
play the CD. In addition, the disc may
not eject resulting in a malfunction.
Remove the rough edges in advance by
using a ball-point pen or pencil as
shown below. To remove the rough
edges, rub the side of the pen or pencil
against the inner and outer perimeter of
the CD.
l
When driving over uneven surfaces,
the sound may jump.
l
The CD player/In-dash CD changer has
been designed to play CDs bearing the
identification logo as shown. No other
discs can be played.
l
Use discs that have been legi timately
produced. If illegally-copied discs such
as pirated discs are used, the system
may not operate properly.
CD Player
In-dash CD changer
l
Be sure never to touch the signal
surface when handling the CDs. Pick
up a CD by grasping the outer edge or
the edge of the hole and the outer edge.
l
Do not stick paper or tape on the CD.
Avoid scratching the reverse side (the
side without a label). The disc may not
eject resulting in a malfunction.
l
Dust, finger smudges, and dirt can
decrease the amount of light reflected
from the signal surface, thus affecting
sound quality. If the CD should
become soiled, gently wipe it with a
soft cloth from the center of the CD to
the edge.
6-14
Interior Comfort
Audio System
MX-5_8V80-EA-06F_Edition1 Page222
Monday, June 12 2006 12:57 AM
Form No.8V80-EA-06F