Filter
Top Products
Black plate (262,1)
8. If it matches the registered code,
“SR1 LOCK” appears for three
seconds which indicates that the code
input has been completed.
9. “SR1 LOCK 100” appears which
indicates that the parental lock is
activated. At this time, mute is on and
no sound is heard.
NOTE
l
If an ID code is not input for ten seconds,
“Err” is displayed and it returns to the
former display.
l
Channel preset buttons 1, 2, 3, 4 and the
auto memory button (scan button) are used
for input of the ID code. Buttons 5 and 6
cannot be used.
Lock cancellation
Setting condition: SAT mode
NOTE
(scan button) refers to the operation for an In-
dash CD changer-equipped vehicle. The auto
memory button refers to the operation for a
CD player-equipped vehicle.
(Releasing a locked channel)
1. Select a channel to be released by
turning the manual tuning dial.
Example: Select the locked channel
(i.e. 100). At this time,
“SR1 LOCK 100” is displayed.
(Registered ID code input preparation)
2. Hold the auto memory button (scan
button), then press channel preset
button 6, hold both buttons together for
1.5 seconds.
3. “ENTER PIN” appears for three
seconds which indicates that it is in
code input mode.
4. “SR1 - - - -” appears, which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example:
When the registered ID code is “2323”,
input “2323”. At this time “SR1 2323”
is displayed.
NOTE
If “Err” is displayed, go to the
“INITIALIZATION OF ID CODE” section to
reset the ID code to [0000].
(Registered ID code input
determination)
6. Determine the input code by pressing
the auto memory button (scan button).
7. If it does not match the registered code,
“SR1 Err” is displayed and then it
returns to “SR1 - - - -”.
8. If it matches the registered code,
“SR1 UNLOCK” appears for three
seconds which indicates that the code
input has been completed.
9. “SR1 100” appears which indicates that
the parental lock is off. At this time,
sound is heard.
NOTE
l
If an ID code is not input for ten seconds,
“Err” is displayed and it returns to the
former display.
l
Channel preset buttons 1, 2, 3, 4 and the
auto memory button (scan button) are used
for input of the ID code. Buttons 5 and 6
cannot be used.
6-44
Interior Comfort
Audio System
Mazda3_8AD2-EA-08K_Edition1 Page262
Thursday, October 9 2008 1:6 PM
Form No.8AD2-EA-08K