Filter
Top Products
Black plate (260,1)
(Master code input determination)
5. Determine the master code which has
been input by pressing the auto
memory button (scan button).
6. “PIN CLEAR ED” appears which
indicates that the master code input has
been completed.
7. The ID code is set to the default [0000]
and the initialization process is
completed.
NOTE
Master code:
The Master Code is used to initialize or re-
initialize the ID code in the event that the code
is not set to [0000] and/or the personalized ID
code is not known. The initialization process
resets the ID code to [0000]. The master code
can potentially defeat the intent of the security
of the parental lock if it is located by persons
not authorized by the owner to access certain
channels.
SIRIUS Satellite Radio Master Code: [0913]
NOTE
l
When a numeric value other than the
master code is input and the auto memory
button (scan button) is pressed, “SR1 Err”
is displayed and then it returns to the
“SR1----” display again.
l
If an ID code is not input for ten seconds,
“Err” is displayed and it returns to the
former display.
l
Channel preset buttons 1, 2, 3, 4 and the
auto memory button (scan button) are used
for inputting the ID code. Buttons 5 and 6
cannot be used.
Change of ID code
Setting condition: SAT mode
When changing the ID code, the new ID
code is input after the previ ous one is
input first.
NOTE
(scan button) refers to the operation for an In-
dash CD changer-equipped vehicle. The auto
memory button refers to the operation for a
CD player-equipped vehicle.
(Registered ID code input)
1. Hold the auto memory button (scan
button), then press channel preset
button 5, hold both buttons together for
1.5 seconds.
2. “ENTER PIN” appears for three
seconds which indicates that it is in
code input mode.
3. “SR1 - - - -” appears, which indicates
that it is ready for code input.
4. Input the registered ID code using
channel preset buttons 1-4.
Example: When the registered ID code
is “2323”, input “2323”. At this time
“SR1 2323” is displayed.
Press 1 for the first digit, 2 for the
second, 3 for the third, and 4 for the
last digit. For example, if your number
is 2323, press 1 three times, 2 four
times, 3 three, and 4 four times. If the
display goes off while inputting, begin
from Step 1.
NOTE
The registered ID code is the default [0000] at
the time of factory shipment. If [0000] results
in “Err” on the display, go to the
“INITIALIZATION OF ID CODE” section to
reset to [0000].
6-42
Interior Comfort
Audio System
Mazda3_8AD2-EA-08K_Edition1 Page260
Thursday, October 9 2008 1:6 PM
Form No.8AD2-EA-08K