Filter
Top Products
Black plate (261,1)
(Verification with the registered ID
code)
5. Determine the input code by pressing
the auto memory button (scan button).
6. If it does not match with the previously
registered code, “SR1 Err” is displayed
and then it returns to “SR1 - - - -”.
7. If it matches with the previously
registered code, “ENTER PIN” appears
again and it switches to code input
mode.
8. “SR1 - - - -” appears, and it is ready for
input of the new ID code.
(New ID code input)
9. Input the new ID code using channel
preset buttons 1-4.
Example: If “1234” is input as the new
code, “SR1 1234” is displayed.
(New ID code input determination)
10. Determine the new ID code which
has been input by pressing the auto
memory button (scan button).
11. “PIN CHANGED” appears for three
seconds which indicates that the new
ID code input has been completed.
12. It returns to the former display.
NOTE
l
If an ID code is not input for ten seconds,
“Err” is displayed and it returns to the
former display.
l
Channel preset buttons 1, 2, 3, 4 and the
auto memory button (scan button) are used
for input of the ID code. Buttons 5 and 6
cannot be used.
Individual channel locking
If a channel is locked, the channel is
muted.
NOTE
l
If the registered ID code is forgotten, return
the ID code to the default [0000]. (See
“INTIALIZATION OF ID CODE” section)
l
(scan button) refers to the operation for an
In-dash CD changer-equipped vehicle. The
auto memory button refers to the operation
for a CD player-equipped vehicle.
(Locking a channel)
1. Select a channel to be locked by
turning the manual tuning dial.
Example: Select channel 100
(Registered ID code input preparation)
2. Hold the auto memory button (scan
button), then press channel preset
button 6, hold both buttons together for
1.5 seconds.
3. “ENTER PIN” appears for three
seconds which indicates that it is in
code input mode.
4. “SR1 - - - -” appears which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example: If
the registered ID code is “ 2323”, input
“2323”. At this time “SR1 2323” is
displayed.
(Registered ID code input
determination)
6. Determine the code which has bee n
input by pressing the auto memory
button (scan button).
7. If it does not match the registered code,
“SR1 Err” is displayed and then it
returns to “SR1 - - - -”.
Interior Comfort
Audio System
6-43
Mazda3_8AD2-EA-08K_Edition1 Page261
Thursday, October 9 2008 1:6 PM
Form No.8AD2-EA-08K