Filter
Top Products
Black plate (153,1)
qCruise Set Indicator Light
This light comes on when a cruising speed
is set.
qActivation/Deactivation
To activate the system, press the ON/OFF
switch.
The cruise main indicator light
illuminates.
To deactivate the system, press the switch
again.
The cruise main indicator light turns off.
WARNING
Keep the ON/OFF switch off when
cruise control is not in use:
Leaving the ON/OFF switch on when
not using the cruise control is
dangerous as it may be switched on
accidentally. This could result in loss
of vehicle control.
qTo Set Speed
1. Activate the cruise control system by
pressing the ON/OFF switch.
2. Accelerate to the desired speed, which
must be more than 30 km/h (19 mph).
3. Press the SET/COAST button and
release it at the speed you want.
Release the accelerator at the same
time.
Don't continue to hold in the button. Until
you release it, speed will continue to drop
(unless you continue to accelerate) and
you'll miss the desired speed.
NOTE
l
The SET function can't be activated
until about 2 seconds after the ON/
OFF switch has been engaged.
l
On a steep grade, the vehicle may
momentarily slow down going up or
speed up while going down.
Driving YourMazda
Starting and Driving
5-19
Mazda6_8W54-EA-06G_Edition1 Page153
Tuesday, July 25 2006 1:52 PM
Form No.8W54-EA-06G