Filter
Top Products
20
3. Select the fuel flow you want to rename and press
ENT. The Device
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
ENTER and use ↑ ↓, ← → to input the desired name for the fuel
flow. Press
ENT. Press EXIT repeatedly to get back to the main display.
To select a Location:
1. Press MENU| MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
ENT. The Device Configuration
menu will appear.
4. Select
LOCATION and press ENT, which will open the Location menu
with following options: Port, Center, Starboard and Unknown.
5. Highlight the desired location and press
ENT. The following message
will appear: Are you sure you wish to change this device's configuration?
5. Select
YES and press ENT. Press EXIT repeatedly to get back to the
main display.
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service. You should never
need this command if you are connecting your unit to a network with
similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults. If, for example, you exe-
cute the Restore Defaults command from your Port Fuel Flow Ad-
vanced Options menu, only the settings for the Port Fuel Flow will be
reset to factory defaults. Other fuel flows on the network will not be
affected.