Filter
Top Products
18
Configuring EP Sensors
All configurable devices are configured through their Device Configura-
tion menus, which may be accessed through the network devices list on
the Bus Configuration menu.
EP-35 Temperature Configuration
To input Device Name:
1. Press MENU|MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the temp sensor you want to rename and press
ENT. The De-
vice Configuration menu will appear with the Device Name dialog box
highlighted.
4. Press
ENT and use ↑ ↓, ← → to input the desired name for the temp
sensor. Press
ENT. Press EXIT repeatedly to get back to the main dis-
play.
To select Temp Type:
1. Press MENU|MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENT. The Device Configura-
tion menu will appear.
4. Highlight
TEMP TYPE and press ENT. The following list of Temp Types
will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well,
Bait Well, Refigeration, Heating System and Unknown.
5. Highlight the desired Temp Type and press
ENT. The following con-
firmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
YES and press ENT. Press EXIT repeatedly to get back to the
main display.
Advanced Options menu
The Temp sensor Advanced Options menu contains two categories: In-
stance and Restore Defaults.