Filter
Top Products
79
To select data for display:
1. From the Map page, press
MENU
|↓ to
O
VERLAY
D
ATA
|
ENT
.
2. Press ↓ or ↑ to select Data Type|
ENT.
Overlay Data command on the Map Menu, at left. Overlay Data Shown
selection menu, right. In this example, we scrolled down the data list
to highlight "Distance." Ground Speed and the Steering Arrow are al-
ready selected, as shown by the check marks beside their names.
When selected, the data type shifts to the top of the data list and a
check mark appears beside the data type. (If you wish, you may now
use ↓ or ↑ to select other Data Types for display.)
3. To return to the previous page, press
EXIT
|
EXIT
.
To turn off displayed data:
1. From the Map, press
MENU
|↓ to
O
VERLAY
D
ATA
|
ENT
.
2. Press ↓ or ↑ to select Data Type|
ENT.
The selected data type disap-
pears from the top of the list and reverts to its previous, unchecked po-
sition. (If you wish, you may now use ↓ or ↑ to select other Data Types
to turn off.)
3. To return to the previous page, press
EXIT
|
EXIT
.
To change displayed data font size:
1. From the Map page, press
MENU
|↓ to
O
VERLAY
D
ATA
|
ENT
.
2. Press ↓ or ↑ to select Data Type|press → or ← to Data Size|
EXIT
.
The selected data type will be displayed in the new size. (To change the
font size for another Data Type, press
ENT
and repeat these steps, be-
ginning with step two above.)
3. To return to the previous page, press
EXIT
.
Tip:
If you wish, you can change the displayed data font size when you
select a data type:
1. From the Map page, press
MENU
|↓ to
O
VERLAY
D
ATA
|
ENT
.