Filter
Top Products
14
Communication Port Wiring Diagrams
Com-1 wiring to receive DGPS position information
from a DGPS receiver.
Com-1 wiring to receive NMEA position information
from some other GPS receiver.
Com-1 wiring to transmit NMEA position information
to another NMEA-compatible device.
Com-2 wiring to transmit NMEA position information
to another NMEA-compatible device.
Mounting the Unit: Bracket or In-Dash
You can install the GlobalMap 7000C on the top of a dash with the
supplied gimbal bracket. It can also be installed in the dash. For an in-
dash mount, consult the factory customer service department. Service
contact information is inside the back cover of this manual.
Bracket Installation
Mount the GlobalMap 7000C in any convenient location, provided there
is clearance behind the unit when it's tilted for the best viewing angle.
You should also make sure there is enough room behind the GlobalMap
7000C to attach the power and GPS antenna/receiver module cables. (A
drawing on the next page shows the dimensions of a gimbal-mounted
GlobalMap 7000C.)
Orange (Receive)
Shield (Ground)
Transmit
Ground
Com-1
To unit
To DGPS
Receiver
Yellow (Transmit)
Receive
Orange (Receive)
NMEA Transmit
To Other
GPS Receiver
Shield (Ground)
Ground
Com-1
To unit
Ground
To Other
Device
Com-1
To unit
Yellow (Transmit)
NMEA Receive
Shield (Ground)
Shield (Ground)
Ground
Com-2
To unit
Blue (Transmit)
NMEA Receive
To Other
Device