Filter
Top Products
15
Power connections for the GlobalMap 3500C GPS unit.
NOTE:
If you're powering a NMEA-2000 buss, you will attach both the
NMEA-2000 Power cable and the unit's Power Supply cable to the
boat's battery. To attach the NMEA-2000 Power cable, connect the
red wire to battery's + and black and shield wires to battery's -.
WARNING:
This product must be independently fused with the en-
closed 3-amp fuse (or equivalent), even if you connect to
a fused accessory or power buss.
If a malfunction happens inside the unit, extensive dam-
age can occur if the enclosed fuse is not used. As with all
electrical devices, this unit could be damaged to a point
that it is unrepairable and could even cause harm to the
user when not properly fused.
CAUTION:
Do not use this product without a 3-amp fuse wired into the power
cable! Failure to use a 3-amp fuse will void your warranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
An optional 8-foot, CA-4 external power cable with a cigarette lighter
adapter is available from Lowrance.
NMEA 0183 Cable Connections
NMEA is a standard communications format for marine electronic
equipment. For example, an autopilot can connect to the NMEA inter-
12 volt
battery
Black wire
Red wire with
3 amp fuse
To unit
Data Cable
Optional power off
switch for salt-
water installations
NMEA-2000 Power Cable
To power a
NMEA-2000
buss,
also
connect
NMEA-2000
Power cable
to the boat's
battery.
External speaker wire (not
used by this unit)