Filter
Top Products
| 39
Waypoints, Routes & Trails | Lowrance HDS Gen2 Touch
Creating Autoroutes/Easy Routes — Entire route mode
1. Activate the cursor and select New on the Chart menu
2. Select New route
3. Tap the screen to place route points
4. Tap Autorouting (Navionics) or Easy Routing (Jeppesen)
5. Tap Entire Route
- The route will appear in preview mode, allowing you to
move any desired route points
¼ Note: In preview mode, Autoroutes and Easy Routes use colors
to highlight safe and unsafe areas in a route. Autoroutes use red
(unsafe) and green (safe). Easyroutes use red (unsafe), yellow
(dangerous) and green (safe).
¼ Note: A warning dialog will appear if any user-entered route points
are in unsafe areas. To relocate an unsafe route point, move the
point and repeat Steps 3 and 4 from Autoroute/Easy Route setup.
6.
Tap Keep
7. Tap Save
8. Input the route name in the Edit route dialog
Creating Autoroutes/Easy Routes — Selection mode
1. Select an existing route from the screen
2. Tap Edit
3. Tap Autorouting or Easy Routing
4. Tap Selection
5. Select the desired route points from the existing route
- Route points will turn red when selected
6.
Tap Accept
7. Tap Keep
8. Tap Save