Filter
Top Products
1
FEATURES
✓ KEYPAD PROGRAMMABLE
✓ 480 ENTRY CODE CAPACITY
✓ 480 TRANSMITTER CAPACITY
✓ SUPPORTS 4 BLOCKS OF TRANSMITTERS WITH 4 FACILITY CODES
✓ WEATHER-PROOF, TAMPER-RESISTANT RADIO ANTENNA
✓ SUPPORTS 1 MODEL MGT SAFETY EDGE TRANSMITTER
✓ 1-6 DIGIT ENTRY CODE LENGTH
✓ 4 INDEPENDENT OUTPUTS (TIMED/TOGGLED)
✓ 4 INDEPENDENT TIMERS
✓ EACH ENTRY CODE CAN BE PROGRAMMED TO ACTIVATE EITHER OR BOTH RELAYS
✓ RELAY CONTACTS ARE FORM “C” (N.O. & N.C)
✓ SOLID STATE OUTPUTS ARE OPEN COLLECTOR (SWITCH-TO-COMMON)
✓ TWO STATUS INDICATORS
✓ COURTESY LAMP
✓ PIEZO SOUNDER
✓ TIMED ANTI-PASSBACK (LAST 3 VALID ENTRIES)
✓ KEYPAD LOCKOUT
✓ TACTILE KEY FEEL
✓ DOOR SENSE INPUT
✓ INHIBIT INPUT
✓ REQUEST-TO-ENTER INPUT
INSTALLATION
To avoid damage to the unit from static discharges, connect the
EARTH GROUND terminal to a good earth grounding point. Suggested
wiring size is 18 AWG for earth ground and power (up to 500 feet
of 18 AWG wire can be run for power, use larger wire for longer
runs). Use 22 AWG or larger (depending on the load) for all other
connections.
✦ CAUTION: If the unit is AC powered, and one side of
the power transformer secondary is connected to earth
ground, connect the grounded side to the “-” power
terminal of the unit.
Select a location for the keypad. For door access control installations,
mount the keypad near the controlled door. For gate control
installations, mount the keypad in clear view of the gate, but far
enough from the gate so the user cannot touch the gate from the
keypad.
★ WARNING: TO AVOID SERIOUS INJURY OR DEATH,
MAKE SURE THAT THE UNIT IS FAR ENOUGH FROM
THE GATE SO THAT THE USER CANNOT TOUCH THE
GATE WHILE OPERATING THE KEYPAD. HOWEVER,
THE GATE MUST BE FULLY VISIBLE FROM THE
KEYPAD.
217350 D IMAGE 3