Filter
Top Products
Beep Sounds on Keystrokes Default: Yes
Selects whether or not the keypad beeps as each key is pressed.
Press: 4 0
#
Sound
#
Sound = 1 for Yes = 0 for No
Beep Sounds During Relay #1 Default: No
Selects whether or not the keypad beeps during Relay #1 activation.
Press: 4 1
#
Sound
#
Sound = 1 for Yes = 0 for No
Beep Sounds During Relay #2 Default: No
Selects whether or not the keypad beeps during Relay #2 activation.
Press: 4 2
#
Sound
#
Sound = 1 for Yes = 0 for No
Beep Sounds During Output #3 Default: No
Selects whether or not the keypad beeps during Output #3 activation.
Press: 4 3
#
Sound
#
Sound = 1 for Yes
= 0 for No
Beep Sounds During Output #4 Default: No
Selects whether or not the keypad beeps during Output #4 activation.
Press: 4 4
#
Sound
#
Sound = 1 for Yes
= 0 for No
Keypad Lockout Count Default: 3 Tries
Sets the number of incorrect entry code attempts allowed before the
keypad “locks out”.
Press: 5 0
#
Attempts
#
Attempts = Number of attempts before lockout (2-7)
Anti-passback Time Default: No Anti-passback
Sets the length of time an entry code will not function after it is used.
Press: 5 1
#
Minutes
#
Minutes = Time in Minutes (1-4)
0 = No Anti-passback
Master Reset
✦ CAUTION: Performing a master reset will clear the entire
memory of the AK-11 and return all programmable options
to the factory default values. ALL ENTRY CODES WILL BE
ERASED.
STEP 1 Disconnect power from the keypad.
STEP 2 Press and hold down the
*
and
#
keys.
STEP 3 Apply power to the keypad, continue holding the keys down
until the red LED starts flashing.
STEP 4 Release the keys. The red and yellow LEDs will remain lit
until the process is complete, then the yellow LED will go out.
Resetting the Master Code
STEP 1 Open the AK-11 case.
STEP 2 Locate jumper JP2. This jumper is used to reset the master
code.
STEP 3 With power applied to the keypad, remove jumper JP2. The
keypad will begin to beep, signaling that the code has been
reset.
STEP 4 Replace jumper JP2.
THE MASTER PROGRAMMING CODE IS NOW 123456.
8